P&K Audio Amp Selector/Loop Selector

[Rocket Roll]

Samo kratak heads-up za Headbone...

"...the biggest problem I had with it was the fact you can't use effects in the effects loop of your amplifier (see the manual on Radial's website)."

...ukoliko to nekom nešto znači. A koga zanima samogradnja, evo projekta: http://www.box.net/shared/mgpafik2n6

[Dersu Uzala]

Interesantno. Prosto da ne verujes. Pa ne vade signal iza preampa i pre faznog obrtaca?!? Something's fishy.


Koja glupost (iz manuala):

Effects such as echo or loop-playing devices, MUST BE CONNECTED BEFORE the Headbone so that their residual or sustaining sound can be disconnected from the input of the amplifiers. This means that you cannot use any type of echo device that prolongs a signal on the amplifier’s effects loop or after the Headbone in your signal chain. Failure to do so could cause the echo to continue to play through the standby amp which, in turn, would continue to amplify the signal without a load. This could cause the amp or the Headbone
to malfunction. The Headbone’s internal resistor load is only designed to support the standby amplifiers residual output. The Headbone is NOT a load box.

Moguce da je Axess Electronics HS2 drukcije resen, ima reviews na Harmony Central pa kome treba nek pogleda.

[Hillybilly]

Ocigledno su stedeli na otpornicima za vestacko opterecenje.
Projekat koji je Rocket okacio nema taj problem.